Guest
Show Posts
1
General Mach Discussion / Grizzly G0519 to a CNC
« on: July 26, 2009, 12:39:33 AM »
I’m looking at getting a small mill like the Grizzly G0519 and want to convert it to a CNC but before I spend some money I want get an idea of the total cost and get the right parts I want to go with Ball screws and servo motors so here the big questions
1 belt drive or direct drive for the servos I would like direct better but?? if belt what ratio
2 what size and torque of servos
3 what size ball screws pitch dia and length
Any help would be great or put me in a better path
This is for a home RC Heli hobby shop cutting Carbon sheets and making small alum 3D bearing blocks need to be accurate
thanks aging
Atv
1 belt drive or direct drive for the servos I would like direct better but?? if belt what ratio
2 what size and torque of servos
3 what size ball screws pitch dia and length
Any help would be great or put me in a better path
This is for a home RC Heli hobby shop cutting Carbon sheets and making small alum 3D bearing blocks need to be accurate
thanks aging
Atv