1
General Mach Discussion / Since PC reset itself, positioning is not correct
« on: September 29, 2015, 10:51:05 PM »
Even when loading known good G files, I get soft limits errors and the cuts don't start at the correct spot in relation to home.
REF ALL HOME works fine, but it doesn't correctly use home to position the parts I am cutting.
Not exactly sure where to start with troubleshooting. Any ideas would be appreciated.
Rick
REF ALL HOME works fine, but it doesn't correctly use home to position the parts I am cutting.
Not exactly sure where to start with troubleshooting. Any ideas would be appreciated.
Rick