Hello Guest it is March 28, 2024, 02:42:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - A1CNC

Pages: 1
1
Just pulled one of these out of 2 feet of snow. The price was right..FREE!
The Hardinge looks to be in good shape and it has a small x-y table on it. I have no manual for it and can't find much info about the cnc control. No pictures of the actual machine yet as it is in the back of my pickup under a tarp with snow again last night,

Anyone know anything about the servo products control?

TIA

2
General Mach Discussion / Mach3 turn locks up pc on start-up
« on: August 21, 2010, 09:31:16 PM »
Please help, I am using a custom screen so that may be the problem I do not know. It used to work fine but this pc's hard drive died a while ago and ever since I replaced the hard drive I have had problems with mach3.
 
Most times when I try to start My session of Mach3 turn it will show the splash scren, then load the lathe screen, and then the pc locks up. I can only turn off the pc by holding the power button in for 3 seconds and then re-trying the whole frustrating process again! Once it finally starts It seems stable.

thanks for any ideas,
Eric


3
Galil / Galil 2140 & Mach No DRO change
« on: January 01, 2010, 08:38:26 PM »
I am starting a conversion of a Supermax mill with an Anilam crusader II control.

I connected one of the linear scales to the ICM2900 to see if it will work with Mach. I have seen the position change in smart term so I know the Galil is seeing the signal. I set-up the plugin in Mach. If I turn the handwheel mach shows a velocity while turning the handwheel but the dro does not change. I did un-check the use position box.

Any Ideas greatly appreciated.
Thanks,
Eric

4
Galil / Where to get 100 pin cable?
« on: October 10, 2009, 09:30:17 PM »
I have a 2140 and the icm 2900. Can anyone point me to where i can pick up a 100 pin cable?

Thank You,
Eric

Pages: 1