Guest
Show Posts
1
General Mach Discussion / Tool offset missed
« on: October 31, 2009, 06:11:28 AM »
Hello all, 
I meet a trouble with Mach 3 Version 3.
When I start operating (auto mode), the tool offset compensation isn't took into consideration. That means the green light which indicate that tool offset is "ON" immediately turns "OFF" while I key "START".
I do not meet such issue with old version...
May somebody can help me ?
Thanks very much in advance.
William.
I meet a trouble with Mach 3 Version 3.
When I start operating (auto mode), the tool offset compensation isn't took into consideration. That means the green light which indicate that tool offset is "ON" immediately turns "OFF" while I key "START".
I do not meet such issue with old version...
May somebody can help me ?
Thanks very much in advance.
William.