Guest
Show Posts
1
General Mach Discussion / Need help Mach 3 Version R2.63 on MW XP HOME w/SP3
« on: July 08, 2009, 10:52:12 PM »
Mach 3 Version R2.63 on MW XP HOME w/SP3 The motor tuning screen does not pop up when trying to access from menu bar config, motor tuning, what is the problem, does anyone know?
I am using the following stepping motors for my 3 axis CNC machine:
#23-305-DS8A 425oz-in bipolar rating, 305oz-unipolar rating,
4.2v, 3A, 200 S/R, 3.2mH, Size #23, Dual Shaft.
I need to calculate few things for the Mach 3 on the motor tunning screen:
The number of steps per revolution, which if correct is 200
*The step resolution of the motor drive, full step, half step, 5, 10, etc., micro
steps
*The reduction ration between the motor shaft and lead screw.
The thread pitch of the screw which is 18TPI.
I am using the following stepping motors for my 3 axis CNC machine:
#23-305-DS8A 425oz-in bipolar rating, 305oz-unipolar rating,
4.2v, 3A, 200 S/R, 3.2mH, Size #23, Dual Shaft.
I need to calculate few things for the Mach 3 on the motor tunning screen:
The number of steps per revolution, which if correct is 200
*The step resolution of the motor drive, full step, half step, 5, 10, etc., micro
steps
*The reduction ration between the motor shaft and lead screw.
The thread pitch of the screw which is 18TPI.