Hello Guest it is March 19, 2024, 02:11:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - denverwelder

Pages: 1
1
General Mach Discussion / mach 3 and the serial port
« on: July 23, 2009, 11:37:02 AM »
Is there any way to write a script to send and receive to the serial port?

2
VB and the development of wizards / Any VB tutorial videos?
« on: July 21, 2009, 05:08:17 PM »
Does anyone know of any VB tutorial videos?  I am really finding this part of Mach difficult.

Thanks

3
General Mach Discussion / adding visual basic objects to the screen?
« on: July 21, 2009, 11:47:48 AM »
We are finding VB difficult with Mach 3 Is there  a tutorial on this anywhere?

specifically right now:

Is it possible to add an OCX object or an active X control to the screen?  We would like to put a Mschart object to record torch tip voltage, and be able to watch the chart as it runs

In general, does Mach3 allow all visual basic objects like the Mscomm, mscharts,etc... to be used?


Thanks in advance.

4
General Mach Discussion / outputs frome keyboard strokes?
« on: July 07, 2009, 05:22:24 PM »
I am trying to get any key on the keyboard to send an output signal to the breakout board.   Seems easy enough but i sure can't get it.  any ideas?

I'm trying to just control a torch tip up or down while it runs and isolated from the program running

Pages: 1