Guest
Show Posts
1
Show"N"Tell ( Your Machines) / Hurco MB1 retrofit
« on: July 05, 2009, 03:06:31 PM »
Hello everyone, new member here getting ready to take on a Hurco MB1 mill retrofit. I've read just about everything on the web that I could find and not much is out there on these mills. This was a perfectly good running machine until the controller started to systematically fail and let it's smoke out! I have a few basic questions and would appreciate any and all feedback that I can get.
I would like to retain the stock Electrocraft DC servos and Max400 drive amps. Can I use something like a Rutex R2040 per axis to convert step & direction to +- 10volts?
As far as motherboards go, I like the features of the C-11 from cnc4pc. Does anyone have any experience with this product or other recommendations?
I look forward to hearing from everyone soon.
Thanks.
I would like to retain the stock Electrocraft DC servos and Max400 drive amps. Can I use something like a Rutex R2040 per axis to convert step & direction to +- 10volts?
As far as motherboards go, I like the features of the C-11 from cnc4pc. Does anyone have any experience with this product or other recommendations?
I look forward to hearing from everyone soon.
Thanks.