Guest
Show Posts
1
General Mach Discussion / Help: My Step pin stay high all the time.
« on: July 03, 2009, 12:13:00 PM »
Hello,
My name is Amit, and I new to this softwere.
I build a simple CNC mechine. until now I build the X and Y axe, and i keep upgrade it all the time.
Until now I use turbocnc for windows, but this is very old and not easy to use softwere, so I decide to move to Mach3.
I start to config the softwere, but I have problem: my Step pin stay all the time high (or low if I config "Step low active")
For exmpale when I open the softwere, and enter JOG mode, in the begin the step pin is low, but when I did even one step, it stay high all the time.
Why this is happen? How I fix it?
Thenks a lot,
Amit Prigozin
My name is Amit, and I new to this softwere.
I build a simple CNC mechine. until now I build the X and Y axe, and i keep upgrade it all the time.
Until now I use turbocnc for windows, but this is very old and not easy to use softwere, so I decide to move to Mach3.
I start to config the softwere, but I have problem: my Step pin stay all the time high (or low if I config "Step low active")
For exmpale when I open the softwere, and enter JOG mode, in the begin the step pin is low, but when I did even one step, it stay high all the time.
Why this is happen? How I fix it?
Thenks a lot,
Amit Prigozin