Guest
Show Posts
1
General Mach Discussion / Mach 3 cutting undersized
« on: July 01, 2009, 07:39:02 AM »
Hello All
I have only recently started using mach 3 and seem to be having a slight problem, I cut some parts from mdf for a project only to find that the milled holes and square pockets were all undersized by 1/2mm but the hole spacing between centres seems correct.
I generated the code using sheetcam and having looked at the files the dimensions seem fine and have noticed that G40 is included which should cancel any cutter compensation.
All the tools in tool table are zero however in tool zero position next to ref tool in the grey parts of the table there are numbers in all fields which are very long since I cannot see the entire number despite stretching the box, could this be causing a problem since I do not seem to be able to make them read zero?
If anyone can help I would very gratefull.
Thanks
Steve
I have only recently started using mach 3 and seem to be having a slight problem, I cut some parts from mdf for a project only to find that the milled holes and square pockets were all undersized by 1/2mm but the hole spacing between centres seems correct.
I generated the code using sheetcam and having looked at the files the dimensions seem fine and have noticed that G40 is included which should cancel any cutter compensation.
All the tools in tool table are zero however in tool zero position next to ref tool in the grey parts of the table there are numbers in all fields which are very long since I cannot see the entire number despite stretching the box, could this be causing a problem since I do not seem to be able to make them read zero?
If anyone can help I would very gratefull.
Thanks
Steve