1
General Mach Discussion / how to disable the toolpath display
« on: October 15, 2009, 03:32:31 PM »
this weekend i tried cutting a high res lithopane and after i generated the g-code the file was about 80mb and had roughly 3.3 million lines. i found the option on the settings screen to turn off the toolpath but this keeps getting reactivated everytime i start mach3 back up again. when trying to load this file it also takes about 5 min to load and if i don't have the toolpath disabled the cnc looses steps all over the place...
how can i disable this so it does not get activated everytime i start mach3 since i really don't use it anyway..
thanks
James
how can i disable this so it does not get activated everytime i start mach3 since i really don't use it anyway..
thanks
James