Topics

1

General Mach Discussion / Newbie: Tool Diameter in Mach problems.

« on: July 13, 2009, 07:58:32 AM »

I am probably doing something wrong but I have set up tool 1 in Mach3 Mill to have a diameter of 3mm in the tool table but it still cuts as though it has a diamter of zero mm.
Any suggestions?

2

VB and the development of wizards / Teach wizard - its gone

« on: June 27, 2009, 07:41:26 AM »

I have just downloaded the latest version of Mach3 and the two tech wizard are no longer included.
Does anybody know of any thirdparty software or any other solution for "teach"

Rod