1
General Mach Discussion / need help with mach 3 setup
« on: December 11, 2009, 12:43:23 PM »
When trying to setup mach 3 I can set the first two pages in the config tab but the motor tuning tab shows nothing when I click on it. What am I doing wrong or is this a glitch in the software?
The motors move the gantry and all the axis move when jogging but only very slowly and when I run the roadrunner program it barely moves.
The video shows a mm set up but I used inches. then I set it in mm but still don't get the motor tuning page.
Thanks Ted
The motors move the gantry and all the axis move when jogging but only very slowly and when I run the roadrunner program it barely moves.
The video shows a mm set up but I used inches. then I set it in mm but still don't get the motor tuning page.
Thanks Ted