Hello Guest it is March 29, 2024, 02:16:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hollyfox

Pages: 1
1
General Mach Discussion / No motor movement. Need xml checked.
« on: June 15, 2009, 08:29:41 AM »
Hey everyone. I have been pulling my hair out with this thing. I have a small 3-axis machine and when I first got it, I installed Win2k, then the Mach3 software, plugged in the machine, set my pins&ports based on pictures of the settings sent with the machine and off I went. The unit ran for four or five months with no problem (other than my own errors in G-code) and was quite happily cutting along. Then I moved and the unit sat for about 6 or seven months. When I started it back up (nothing had changed. Same computer same cable, ect) none of the motors will run at all.

Would someone please take a look at my xml file and see if anything glaring shows up? I need to get this going. I have thirty years of troubleshooting expoerience and have come to the conclusion that something on the computer has changed and I am about to format the hard drive and start from scratch. Before that, I would like to know if there is anything simple that I have overlooked.

Thanks.

Hollye

Pages: 1