Hello Guest it is March 28, 2024, 03:35:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jimw

Pages: 1
1
General Mach Discussion / problem cutting acrs
« on: June 12, 2009, 12:44:30 PM »
Sorry if this was covered in another thread.

I have a Syil X2 mill and a Mach 3 controller.  I used Bobcad to draw an arc and when I cut it, it has a odd spot at the top of the curve. Do I have play in the system or some other problem?  The lower arc is being cut from right to left and the upper left to right.

Please see attached photo.

Thanks,

Jim.


Pages: 1