1
General Mach Discussion / Trying to run a router table.
« on: October 13, 2011, 03:16:44 PM »
I'm trying to run an XYZ router table. I'm having trouble setting the Z axis and keeping it where I want it. I want to run a dry run of the part I'm cutting to see if the thing will cut. I'd hoped to set the the Z axis an inch over my substrate and run a test cut by fooling the machine into thinking it was in the 0.5 inch position to start. The machine keeps fooling my by going to the wrong depth.
Is there a way to do this?
Thanks,
Lindsay
Is there a way to do this?
Thanks,
Lindsay