1
General Mach Discussion / Z axis on my mill cutting at different depths
« on: June 15, 2009, 01:59:29 PM »
I have a Syil X4 Plus and Mach 3 controlling it. I had a part that was .625" tall and I needed to cut a counterbore .475" deep in 2 places. The first cut was much too deep and the second cut went all the way through the part into my vise's soft jaws. I used the Syil X4 profile in the support section, so I have not altered any of the settings.
Is this likely a motor seed/acceleration issue? My speed is maxed. Should I crank it down a bit? I am also using an older laptop until I can come up with a better computer.
Is this likely a motor seed/acceleration issue? My speed is maxed. Should I crank it down a bit? I am also using an older laptop until I can come up with a better computer.