1
General Mach Discussion / 3+2 Drilling
« on: July 29, 2009, 05:00:54 PM »
Hey,
I am trying to generate gcode for Mach3 that can do 3+2 drilling in different workplanes using Powermill and PM Post. Getting PM Post to actually produce code to do this was tricky enough for me but for some reason it doesn't do it properly. I can drill in the XY plane no problem, but for some reason when it positions itself to drill in the YZ plane it actually just drills down into XY plane again.
Does anyone know of a way to create a subroutine of gcodes that can manipulate the workplanes and allow me to drill in them?
Regards,
Tyler
I am trying to generate gcode for Mach3 that can do 3+2 drilling in different workplanes using Powermill and PM Post. Getting PM Post to actually produce code to do this was tricky enough for me but for some reason it doesn't do it properly. I can drill in the XY plane no problem, but for some reason when it positions itself to drill in the YZ plane it actually just drills down into XY plane again.
Does anyone know of a way to create a subroutine of gcodes that can manipulate the workplanes and allow me to drill in them?
Regards,
Tyler