Guest
Show Posts
1
General Mach Discussion / Motors willl not move
« on: May 23, 2009, 12:58:55 PM »
I cannot get movement out of my motors. At one point, they worked. Started the backlash adjustments (bad idea) and then lost all motor movement.
Reloaded Mach 3, verified pin numbers, Dell Dimension 8100 desktop (this is the only application running after erasing itunes my kids loaded), driver test states the system under mach 3 is excellent, my estop still works pin 10 with 4.35 volts at the end of the cable, my XML file is attached, the Keling Technology motors lock up when the power is on and spin smoothly when the power is off, jogging works on the screen but no voltage on any of the pins.
Any help is appreciated! John
Reloaded Mach 3, verified pin numbers, Dell Dimension 8100 desktop (this is the only application running after erasing itunes my kids loaded), driver test states the system under mach 3 is excellent, my estop still works pin 10 with 4.35 volts at the end of the cable, my XML file is attached, the Keling Technology motors lock up when the power is on and spin smoothly when the power is off, jogging works on the screen but no voltage on any of the pins.
Any help is appreciated! John