Hello Guest it is March 28, 2024, 07:50:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jim@PC

Pages: 1
1
General Mach Discussion / Mach 3 compatibility questiion.
« on: May 20, 2009, 03:55:38 PM »
Our company is currently trying to demo your Mach 3 CNC Controller software and we have a few questions I was hoping somebody could help answer for us.

First off, we are using a Vision 2448 Router and were wondering if the Mach 3 software is compatible with this piece of hardware. We are currently controlling the router with a hardware control panel. If your software is compatible with our machine, are there steps on how to directly hardwire the computer to the router and also configure the software to get it operational with the router?

Also, if compatible, is there a way to control the z axis when x and y axis’s are in motion while running a job?

Any help would be greatly appreciated

Jim

Pages: 1