Hello Guest it is July 27, 2021, 05:30:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - grossmanator

Pages: 1
1
General Mach Discussion / Toolpath Perspective upon Regen Toolpath
« on: April 01, 2010, 10:49:36 PM »
Hi all,

Because of the way my router is setup relative to my computer I would like to change the perspective of the toolpath that is automatically chosen when you double click on the toolpath area in the toolpath screen. By default, mach 3 sets up as positive y, right as positive x, and out of the screen as positive z. I would like to modify these settings such that when I double click on the toolpath screen it resets the perspective to: right as negative x, up as negative y, and out of the page as positive z. Anyone know how to go about doing this?

thanks a bunch,

- Will

Pages: 1