1
General Mach Discussion / Moving work within table display
« on: May 15, 2009, 12:48:13 AM »
Guys,
I'm able to move a piece of work closer to the X=0, Y=0 point, but the red traces that originated at the XY point are now redirected off the table display, and then back to the work piece. Is there a way to change this, and have the traces originate at the Xy point directly to the work piece? I hope you can understand what I'm trying to accomplish.
Marv Frankel
Los Angeles
I'm able to move a piece of work closer to the X=0, Y=0 point, but the red traces that originated at the XY point are now redirected off the table display, and then back to the work piece. Is there a way to change this, and have the traces originate at the Xy point directly to the work piece? I hope you can understand what I'm trying to accomplish.
Marv Frankel
Los Angeles