Hello Guest it is May 07, 2021, 07:33:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rat7734

Pages: 1
1
General Mach Discussion / g code for a axis
« on: May 28, 2009, 06:18:10 PM »
Could someone tell me what line of this code makes the a axis turn a full 360 degrees and how can I make it stop at 90 degrees instead?

G0 G49 G40  G17 G80 G50 G90
M6 T1(TOOL DIA. 0.25)
G20 (Inch)
M03 S600
M08
G00 G64 A0.0
Y0.0 X0
G00 G43 H1  Z.5
M98 P0001 Q60
X0
Z0.0
M5 M9
M30


O0001
(Start_pos = .05)
G01 Z-.05 F3
X-5.5 F3
G00 Z.075
X-0
G01 Z-.075F3
X-5.5 F3
G00 Z.050
X-0
G91 A6
G90
M99


Thanks as you can probably tell I am new to editing g code.
Ray

Pages: 1