Hello Guest it is October 16, 2021, 02:02:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - frmoul

Pages: 1
1
General Mach Discussion / Problem configuring ncpod
« on: May 14, 2009, 01:33:13 PM »
Hello all,

I have a problem to setup mach3 for ncpod.
The communication between Mach3 and ncpod is OK, but I don't manage to setup the soft to make move motors.
The following picture is my actual setup of mach 3, please tell me what is wrong.



Freddy

2
NC Pod / Problem configuring NC Pod
« on: May 08, 2009, 04:29:13 PM »
Hello,

I'm new on this forum.

I read all topic about Nc Pod.

I'm setting up my laptop to drive the milling machine I'm finishing.

I've some problems with Nc Pod configuration.

I don't manage to update fireware :
- I intalled USB drivers provided by OEM
- My laptop run on win XP and use USB 2.0
- The nc pod can be disconected (by soft) in windows just like a USB key
- Nc pod controller is well intalled in setting panel (it exist on it and windows consider that the controller has no problem)
Unfortunately, an error message aware me that the updating program of the fireware don't find nc pod which is supplied with DC 5V and plugged to the PC

Due to this problem, ncpod plugin diagnostic shows nothing


Thank for you help in advance.

Freddy

Pages: 1