Hello Guest it is September 17, 2019, 11:45:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - didjado

Pages: 1
1
General Mach Discussion / History log to diagnose limit switch prob
« on: May 19, 2009, 06:52:15 PM »
Hi All

i have a dodgy limit switch... but not to sure which one... the problem arrises once every 2-3 hours or so ... but some times can happen in 10 minutes......

the history screen only tells me tha it was a limit but not which one .....

any ideas

2
Feature Requests / standard views buttons on program tab
« on: May 15, 2009, 08:55:15 PM »
Hi

i would like to see for the tool path window a few standard view buttons.... like top side and front or even at minimum reset to top squared

3
Hi

i cannot load the complete g code file into the demo version of mach3... the file originates from DeskProto software

and at  the below... stops loading
G1 X8.584 Y8.216 F700
G1 X8.805 Y7.995

about 1/10 of the file is being loaded

any ideas... the file is attached

Pages: 1