Topics

1

General Mach Discussion / Z axis 0

« on: May 02, 2009, 10:42:51 AM »

I looked but can't find this in the tutorials. When I set Z 0, the DRO flashes 0.375 then sets 0. If I only regen 1 time, the z axis cuts air. If I regen 3-4 times it works like it should. One thing I noticed is the DRO is not bold like the rest of them. I'm sure it's something simple, but I'm stumped.

Jim

2

General Mach Discussion / Wizards

« on: April 16, 2009, 10:06:22 AM »

Is there a way to save the G-Code generated by a wizard?

Jim