Hello Guest it is August 15, 2020, 02:12:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Nick1983

Pages: 1
1
General Mach Discussion / 4 Axis Waterjet Cutting In Mach3
« on: April 13, 2009, 01:39:04 PM »
Does anyone have anyone have experience with 4 axis waterjet cutting running through Mach 3.  I am unable to get it to work properly.  When the head rotates it is naturally higher than when it is at 90 degrees.  I guess is there a way in Mach to have it compensate a Z and x movement to hold the head in the same position above the material as when it is doing straight 2d cut. 

Thanks
nick

Pages: 1