Guest
Show Posts
1
Feature Requests / mach3
« on: April 12, 2009, 10:43:31 PM »
Hello all,
New to cnc and I'm looking for step by step instruction on how to set up my cnc router in mach 3 to the point that i can start to cut some thing
My cnc is a rockcliff breakout board and drivers and the stepper motors are all purchased from www.rockcliffmachine.com and i have mach3 configured to the point that i can jog the x,y,z axis.
Now i am trying to find out what to do next i have read so many things in the forum that i am not sure what to do next
i have attached a pic of my machine
thx in advance 59caddy
New to cnc and I'm looking for step by step instruction on how to set up my cnc router in mach 3 to the point that i can start to cut some thing
My cnc is a rockcliff breakout board and drivers and the stepper motors are all purchased from www.rockcliffmachine.com and i have mach3 configured to the point that i can jog the x,y,z axis.
Now i am trying to find out what to do next i have read so many things in the forum that i am not sure what to do next
i have attached a pic of my machine
thx in advance 59caddy