1
VB and the development of wizards / Passing parameters to a macro - where is this documented?
« on: March 16, 2011, 03:43:13 PM »
As title. I understand that is possible to pass parameters to a macro, but where do I learn how to do this?
Say I want to tie my code to M689 macro, and I want to use it as M689 C23.45 .
The parameter refers to the C axis and the number would be used for a G01 move at the current feedrate.
It does not seem to be explained in the Mach Programmers Reference. Is it in the Cypress Basic manual?
Also, while I have your attention, the Programmers Reference keeps going on about CB Constants. I can't find these anywhere. Are these the same as VB Constants in the Wiki? Are they documented anywhere other than the Wiki?
Thanks.
Say I want to tie my code to M689 macro, and I want to use it as M689 C23.45 .
The parameter refers to the C axis and the number would be used for a G01 move at the current feedrate.
It does not seem to be explained in the Mach Programmers Reference. Is it in the Cypress Basic manual?
Also, while I have your attention, the Programmers Reference keeps going on about CB Constants. I can't find these anywhere. Are these the same as VB Constants in the Wiki? Are they documented anywhere other than the Wiki?
Thanks.