1
General Mach Discussion / Yet another limit switch problem.
« on: April 08, 2009, 12:12:52 AM »
I have a strange problem with my limit/home switches.
I have three limit switches in series, normally closed. They're all on Port 1, Pin 11 and this is correctly set.
If I try to "Ref All Home" the axes all move a little bit, slowly (the amount that they move seems random) and then halt, but they don't make it to the switches.
If I activate a limit switch by hand while jogging the axes, the axes do not stop, they just slow waaaay down.
Help?
I have three limit switches in series, normally closed. They're all on Port 1, Pin 11 and this is correctly set.
If I try to "Ref All Home" the axes all move a little bit, slowly (the amount that they move seems random) and then halt, but they don't make it to the switches.
If I activate a limit switch by hand while jogging the axes, the axes do not stop, they just slow waaaay down.
Help?