Guest
Show Posts
1
PoKeys / pokeys and G100 question
« on: March 30, 2009, 06:05:01 AM »
H,
I have currently a G100 set up to control my cnc, and that works just fine, but now I want to build a toolchanger that requires more io than available on the Grex.
I saw on the docs that pokey uses the same addresses as the G100. so now my question: can G100 and pokeys55 be used at the same time for digital outputs in mach? or is that going to mess up the system?
thanks,
Bram
I have currently a G100 set up to control my cnc, and that works just fine, but now I want to build a toolchanger that requires more io than available on the Grex.
I saw on the docs that pokey uses the same addresses as the G100. so now my question: can G100 and pokeys55 be used at the same time for digital outputs in mach? or is that going to mess up the system?
thanks,
Bram