Guest
Show Posts
1
General Mach Discussion / Digitize wizard not saving to file properly
« on: March 13, 2009, 07:32:20 PM »
Hello,
I am having problems with the digitizing wizard. When the wizard starts, it prompts me to provide a filename. It then goes about gathering the point cloud. During the digitizing procedure, however, the limit switches will occasionally go off without being pushed. When the gcode stops running, not all of the points will have been written to file.
For example, I started running the wizard at 1 PM today. At about 1:30, the limit switch went off. I reset the switch and continued scanning. At 3:30, the scan finished. However, the file did not include all of the points. It was last modified at 2:00, which means that it recorded _some_ values after the limit switch was triggered, but not all of them. Has anyone had this problem before?
Thanks,
Kyle
I am having problems with the digitizing wizard. When the wizard starts, it prompts me to provide a filename. It then goes about gathering the point cloud. During the digitizing procedure, however, the limit switches will occasionally go off without being pushed. When the gcode stops running, not all of the points will have been written to file.
For example, I started running the wizard at 1 PM today. At about 1:30, the limit switch went off. I reset the switch and continued scanning. At 3:30, the scan finished. However, the file did not include all of the points. It was last modified at 2:00, which means that it recorded _some_ values after the limit switch was triggered, but not all of them. Has anyone had this problem before?
Thanks,
Kyle