1
Third party software and hardware support forums. / spindle speed control with Galil 1842?
« on: May 29, 2007, 11:51:13 PM »
I am setting up a Galil DMC-1842 to run with Mach and wondered if I can do spindle speed control with it? I just assumed it would have some extra analog outs that could be used for this, but I do not see any on the spec sheet. I picked up a cool Yaskawa VS-606V7 VF drive on ebay to use for spindle speed control. It takes all kinds of speed control ref signals, like 0-10v or 4-20 ma, or pwm . What would be the best way to to control spindel speed with this Galil bd and a VF drive via Mach?
Thanks,
Doug Danielson
Thanks,
Doug Danielson