Hello Guest it is September 21, 2019, 10:55:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - el4al

Pages: 1
1
General Mach Discussion / CV distance
« on: May 24, 2009, 06:26:08 AM »
HI... just wanted to know can I set the CV disance to 1 instead of 180 ?

2
General Mach Discussion / PLASMA SPEED
« on: April 09, 2009, 02:38:28 PM »
Hi everyone .... well I am new here but not with mach !
well the thing is that how can we make the movement faster in plasma  mode ? and I need the machine be more accurate while its on full speed ! the thing is that when I select the exact stop at the motion mode option the movement will be very slow  but very accurate ! but I want the machine use the constant velocity so I can have the speed ! My feed rate is at 18000 but when I select exact stop I think it turns to 100 ! its that slow !
so the find out that when I use PLASMA mode its much better ! but I need a bit more speed ! while when it reaches arc or movement of Z it slows down for more accuracy in details ! by the way I make 3D moulds !
thank you for reading my post and I am looking forward for your reply !!!!....  ::) ;) :)

Pages: 1