Hello Guest it is March 28, 2024, 07:33:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sully3535

Pages: 1
1
General Mach Discussion / Z axis stopped working
« on: February 19, 2018, 06:48:01 AM »
Everything was working fine through several runs and then the z axis stopped working properly. x and y still work fine. I just replaced the power supply and this fixed it before. On the ports and pins page z axis is checked. Am I missing something?

2
My motors work for about 15 seconds then the pulse frequency drops from @29000 to 1000 and is erratic from there. Windows XP.

3
General Mach Discussion / MAch 3 stops working
« on: February 10, 2018, 12:27:06 PM »
When I reboot my computer mach 3 will move my router normal for about 15 seconds. Then it stops moving. motors make noise but little or no movement.

4
General Mach Discussion / Machine goes crazy
« on: May 14, 2010, 04:34:24 PM »
I write the g-code with BOBCAD and when I try to run it with MAZCH3 it goes to the start point and dives deep into the material.
Any ideas why?

5
General Mach Discussion / Motors not moving correctly
« on: March 08, 2009, 08:07:41 PM »
The motors on my machine move in spurts if at all. If I uninstall and reinstall Mach3 they will work for 5-10 minutes. What is causing this?

Pages: 1