Hello Guest it is November 29, 2021, 12:01:29 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - K-Bar03

Pages: 1
1
General Mach Discussion / Motor/screw configuration?
« on: March 01, 2009, 01:24:05 PM »
Hi All, I have my new router build done and am setting up Mach3. My steppers are turning using the G540 XML file. Every thing runs fine, I just need to figure my travel setting out.
Hopefully someone can help out.

specs:

Steppers are, Keling KL23H284-35-4B   387 oz-in
Controller is Geko G540
A and Y axis screw are McMasterCarr 5 Start ACME 2 turns for 1"
Z axis is THK KR33 ballscrew/actuator with 10mm per one turn.

My config is setup as inches.




Pages: 1