1
PoKeys / Changing Charge Pump frequency
« on: October 13, 2016, 08:49:38 PM »
HI
Planning to use a 57CNCdb25 USB to parallel port unit on my existing parallel port connected CNC machine.
Have just realised I’m possibly going to have a problem with incompatible charge pump frequencies.
The 57CNCdb25 generates a 5KHz signal but the breakout board that it will interface to rquires a 12.5KHz input signal.......................
Does anyone know if it’s possible (and how it can be done) to change the 57CNCdb25 charge pump to generate a 12.5KHz output?. I’m hoping it would likely be a simple software change.
Can anyone help please?
Thanks
Richard
Planning to use a 57CNCdb25 USB to parallel port unit on my existing parallel port connected CNC machine.
Have just realised I’m possibly going to have a problem with incompatible charge pump frequencies.
The 57CNCdb25 generates a 5KHz signal but the breakout board that it will interface to rquires a 12.5KHz input signal.......................
Does anyone know if it’s possible (and how it can be done) to change the 57CNCdb25 charge pump to generate a 12.5KHz output?. I’m hoping it would likely be a simple software change.
Can anyone help please?
Thanks
Richard