Hello Guest it is October 16, 2021, 03:09:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - JEEPLESS

Pages: 1
1
General Mach Discussion / New Guy . . . Old problem??? - motors not turning
« on: February 20, 2009, 12:16:16 PM »
Hello all.

I am in the process of converting a DOS based CNC Crafter 1914 over to Mach 3 and am using the Campbell Designs Combo board.  I can see that Mach 3 is operating with the combo board (I see the step and direction LEDS change with jog state).  The limit switches also trigger the combo board and Mach 3.  Motor outputs are set as follows:

X STEP:  PIN 2
X DIR:    PIN 6

Y STEP:  PIN 3
Y DIR:    PIN 7

Z STEP:  PIN 4
Z DIR:    PIN 8

The motors are Applied Motion Products 5034-349 and the drivers are Applied Motion Products 7080.  The drivers do operate the motors in test mode.  Any help is appreciated.  Thank you in advance.

Matt

Pages: 1