Hello Guest it is November 28, 2020, 12:16:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Atlas56

Pages: 1
1
Screen designer tips and tutorials / How to DRO Question
« on: September 25, 2009, 12:59:09 PM »
How do I get a DRO entry to do a calculation or run a subroutine after a value is entered. For example you enter a value in the DRO, press enter and then a subroutine in the screen set run.

2
Screen designer tips and tutorials / Screen BMP Creator/Editor
« on: May 19, 2009, 01:14:48 PM »
What .bmp program would you reccommend for editing and creating bmp's for Mach3 screens? Something easy to use and not to costly.

3
General Mach Discussion / Part Coords and Program Coorrds Difference
« on: April 01, 2009, 05:12:03 PM »
What is the difference between Part Coords and Program Coords button selector in Mach3Turn in manual screen 1024.lset? The x & z value are always the same. I tried manually entering a value. still both the same.

Pages: 1