Guest
Show Posts
1
General Mach Discussion / BOARD PROBLEM HELP REQUIRED
« on: March 11, 2009, 10:04:42 AM »
Hi all, appologies if this is in the wrong forum...
i have connected all my motors and power etc to the controller board, loaded MACH3 sotware, went to run the motors and i appear to be having problems.
If i tell x axis and y axis to move they are fine, however if i tell z axis to move the motor does nothing but x motor and y motor both vibrate. i have soldered all of the ends of the wiring, to give a good connection, ensured all connections are tight and secure, uninstalled software and reinstalled it but it makes no difference...
ANY TIPS
Anything would be appreciated as it is now delaying the project
cheers
stephen
i have connected all my motors and power etc to the controller board, loaded MACH3 sotware, went to run the motors and i appear to be having problems.
If i tell x axis and y axis to move they are fine, however if i tell z axis to move the motor does nothing but x motor and y motor both vibrate. i have soldered all of the ends of the wiring, to give a good connection, ensured all connections are tight and secure, uninstalled software and reinstalled it but it makes no difference...
ANY TIPS
Anything would be appreciated as it is now delaying the project
cheers
stephen