1
General Mach Discussion / Port1 pins not working?
« on: February 04, 2009, 12:51:15 AM »
Just loaded Mach3, and can't seem to get a signal to the motors.
After triple checking to make sure Axes are set, and Jog is on, I still can't seem to get any change in the Pins status on the Diagnostics menu. (screenshot link below). It doesn't seem to matter which pins I set the motor axis to, the same green indicators are shown. Mach acts like it thinks the motors are doing their thing... the only problem is that they're NOT.
http://cncetc.com/DiagnosticScreenshot.TIF
http://cncetc.com/Mach3Mill.xml
Thank you very much for your help!!!!
After triple checking to make sure Axes are set, and Jog is on, I still can't seem to get any change in the Pins status on the Diagnostics menu. (screenshot link below). It doesn't seem to matter which pins I set the motor axis to, the same green indicators are shown. Mach acts like it thinks the motors are doing their thing... the only problem is that they're NOT.
http://cncetc.com/DiagnosticScreenshot.TIF
http://cncetc.com/Mach3Mill.xml
Thank you very much for your help!!!!