Hello Guest it is November 28, 2021, 06:50:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DanB

Pages: 1
1
General Mach Discussion / Feedrate override wont work
« on: August 20, 2009, 10:37:44 PM »
I'm currently using CandCNC's screenset for plasma cutting and recently i needed to use the option Feedrate override and it wont work the percentage changes and the FRO number changed but the Unit/Min stayed the same and the cutting didnt go any faster..

any suggestion on how to enable it

Pages: 1