1
General Mach Discussion / X0Y0 Jumping?
« on: February 15, 2010, 10:45:49 PM »
Howzit Guys...
Please help...
I'm engraving with Mach3 Mill and my fonts seem move or lose the X0Y0 position.
There is no z axis feed in the g code, meaning always G1 Z0.000 and I manually feed down .002" and repeat thesame simple font G-code cycle again.
The first few times is O.K., but, soon after, it engraves the fonts as if from another reference point.
I engraved others and never had this problem before.
The piece is secure..
Thanks for viewing..
(Click on the image for enlargement)
Alton - Cue Caps
Please help...
I'm engraving with Mach3 Mill and my fonts seem move or lose the X0Y0 position.
There is no z axis feed in the g code, meaning always G1 Z0.000 and I manually feed down .002" and repeat thesame simple font G-code cycle again.
The first few times is O.K., but, soon after, it engraves the fonts as if from another reference point.
I engraved others and never had this problem before.
The piece is secure..
Thanks for viewing..
(Click on the image for enlargement)
Alton - Cue Caps