1
General Mach Discussion / Installation Problem - Driver Test will not run
« on: January 26, 2009, 09:27:19 PM »
Have had Mach 3 loaded and running for several years. Mother board died so as long as I am setting up new computer decided to load latest lockdown version. New computer is a P4 2.8 ghz with a new hard drive and a new install of windows XP Pro. Installed Mach3 but DriverTest will not run and when I start the program the motor tuning screen will not run either. Parallel port # is correct and it is configured as EPP+ECP. Driver shows up in system Hardware. Rebooted several times. I assuming I have done something stupid. It has been several years since I last installed it and since it worked for what I needed I didn't change it.
Any ideas?
TIA
Bruce Buchner
Any ideas?
TIA
Bruce Buchner