Hello Guest it is January 23, 2020, 08:58:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - enrique

Pages: 1
1
General Mach Discussion / run fron here
« on: January 26, 2009, 07:43:19 AM »
hello folks
well i have been using mach3 for a couple of years with a taig micro mill without software limits and machine coords set in a very basic fashion ...but have had plenty of good runs with no real problems....yet ..however i found out that i needed to set my backlash compensation as my rotary stuff was getting thinner on the x (and probably the flats too but) i hadnt really noticed until today when cutting a ring design ..what i want to know is can i use the go to or similar command to move to a particular point in my job  and run from it ...i think i have used "run from here" before but cant remember how i used it ...im going to try anyway ..but do i need software and machine limmits set to do this ?   

Pages: 1