Guest
Show Posts
1
General Mach Discussion / Advice sought on a version upgrade of Mach3
« on: February 24, 2010, 08:34:36 AM »
Hi, I have a small CNC mill using servos that I bought 2nd hand on eBay. It uses Mach3 release 2.45 and I am wondering about upgrading to the current version.
Are there any things to bear in mind when doing this? Pitfalls? Could any files or settings get lost? I am a newbie in machine control. I should add that the mill does have a problem, I think that one of the axes is not initialising properly, and I'm thinking that it's better to investigate using the current version, 3.042...
Any thoughts for or against approach that would also be welcome.
Are there any things to bear in mind when doing this? Pitfalls? Could any files or settings get lost? I am a newbie in machine control. I should add that the mill does have a problem, I think that one of the axes is not initialising properly, and I'm thinking that it's better to investigate using the current version, 3.042...
Any thoughts for or against approach that would also be welcome.