Hello Guest it is August 14, 2020, 01:28:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - storenfwi

Pages: 1
1
Hey,

   I am new to Mach3, and am still trying to figure it out. I have run into a problem, however, and any adivce would be appreciated. The problem is that my motors are powered up, then for example, the x or y axis do a long run in a 3D cut. After running the length, it happens that it took so long that the perpendicular motor powered down. In powering back up, the motor stalls, and so it misses that slight jog to align the next long run. Is there any way to configure Mach3 to keep the motors powered up longer, so they do not stall as such?
   Thank you, all who reply.

Pages: 1