Topics

1

General Mach Discussion / Having Problems Getting Mach3 to work

« on: July 06, 2009, 04:29:01 PM »

When i first got my router i tested with Mach3 on my personal desktop machine and it worked fine.
Now if i try to install Mach3 on a different computer it loads fine but it doesnt send a signal to my machine or something. No Movement, Nothing.
I try to jog around but my machine doesnt budge. I know it isnt my router cuz it works under other programs.
Any help or thoughts on the subject would be helpful. Thx.

2

General Mach Discussion / New User Needs Help With Set-Up Problems!!!!!!!!

« on: January 11, 2009, 12:13:16 AM »

I have a Zenbot router with a xylotex controller but im having a few problems. As far as i know i have all the pins set-up correctly.
I can jog around with it. But when i load a part file then the part picture is off to the side of my table outline. See Example.
Also i need help with touching off my tools or something because my z axis doesnt come down while running and the tool is off table a little bit.
Please Help!!!!!!!!!!!!!!!!!
Im dying to start using this machine. Over-excited you could say.

Thanks for any and all support.

Darren

P.S. I forgot to mention that the machine does not have limit switches. I might need help with homing.