Topics

1

General Mach Discussion / Controlling twin y-axis screws

« on: March 25, 2012, 01:04:09 PM »

Building a router to mill traces in PCB.  I have a gantry, which I have twin screws on the Y-axis.  One side is hooked to the Y-axis and the other side is hooked to the A-axis.  I am not quite sure how to sync these two axis to one axis command.  Can any one point me in the correct direction?  Thanks.

2

VB and the development of wizards / Key Trapping Inside Cypress Enable Scripting

« on: September 06, 2009, 11:10:41 AM »

Hi,
I am writing an Cypress Enable Scripting application inside of Mach3 programming environment.  

Have set up a user defined LED to sense a Halleffects transducer and used input#1 in the Mach-3 to indicate one pulse per revolution. While in an loop I will count the revolutions and accumulate. Does anyone know how to see input#1 in VB?

Does any one know of a way to trap (Esc) Key when pushed (chr$(27)) while in a loop in VB
Can not find an equivalent for Inkey which is an old way to trap key strokes.  Any ideas?

Thanks to all.