1
SmoothStepper USB / Strange Warning Message
« on: November 17, 2010, 04:45:29 AM »
Hi, I just installed a Smooth Stepper in My mill, and when I start the Mach3 up, I get a warning message that reads: Port 1 Pin 2 is assigned 2 times,
Port 1 Pin 3 is assigned 2 times, etc. One line for each of the outputs I am using, pins 2 through9. I de-selected the parallel ports in the ports and pins section but the message persists. What does it mean? Otherwise than that, the unit looks to work perfectly. Don
Port 1 Pin 3 is assigned 2 times, etc. One line for each of the outputs I am using, pins 2 through9. I de-selected the parallel ports in the ports and pins section but the message persists. What does it mean? Otherwise than that, the unit looks to work perfectly. Don