Hello Guest it is September 20, 2019, 05:15:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Turk

Pages: 1
1
I just added a second parrallel port to operate a MPG.  Finally got it working but now when I press the enable button to activate JOG, the spindle button flashes and the spindle goes to the speed in the DRO.  The MPG is set up on port #2 and the serial is Com 1.  There must be settings in Mach, or will I have to rewire the MPG to another output.  Any Ideas.

Pages: 1